Ultimaker original (or plus) feeder damper 3D for print
4224 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
I use this on my new Ultimaker Original Plus, to significantly reduce noise level of the machine.
You might also want to print some feet as well, while you have the flex material loaded anyway. Like Daids: https://www.youmagine.com/designs/ultimaker-noise-reduction-feet or whichever you like best.
Settings to start with:
I used clear Ninjaflex on UMO+
Nozzle temp. 242°C
Bed temp. 50°C
Fan off
Print speed 25 mm/s (constant for everything incl. infill)
Gap speed 250 mm/s
Retraction off
Layer hight 0.15 mm
Wall thickness 1 mm (top, bottom, sides)
Infill 40%
Flowrate 130%
Print one at a time, no need for additional plattform adhesion, or support.
The feeder damper should be oriented 'feeder side' (flat side) down. The inner back wall is slightly angled to print nicely without support.
Put the zip-ties in a loop through the rectangular holes of the pegs and through the middle wall. For dual extruder setup / back left extruder slot, use only the top row to fasten. Otherwise you will interfere with the Z-endstop switch!
Happy printing everyone!
Best regards Frederik
- SoftPLA
- InnoFlex
- any TPE filament you have
- one, or two zip-ties...
Designer
Frederik Brückner3d model description
Easily decouple your original feeder from the housing. Huge benefit in noise reduction without sacrificing functionality and puts on less than 15mm to... the depth of your machine.I use this on my new Ultimaker Original Plus, to significantly reduce noise level of the machine.
You might also want to print some feet as well, while you have the flex material loaded anyway. Like Daids: https://www.youmagine.com/designs/ultimaker-noise-reduction-feet or whichever you like best.
Settings to start with:
I used clear Ninjaflex on UMO+
Nozzle temp. 242°C
Bed temp. 50°C
Fan off
Print speed 25 mm/s (constant for everything incl. infill)
Gap speed 250 mm/s
Retraction off
Layer hight 0.15 mm
Wall thickness 1 mm (top, bottom, sides)
Infill 40%
Flowrate 130%
Print one at a time, no need for additional plattform adhesion, or support.
The feeder damper should be oriented 'feeder side' (flat side) down. The inner back wall is slightly angled to print nicely without support.
Put the zip-ties in a loop through the rectangular holes of the pegs and through the middle wall. For dual extruder setup / back left extruder slot, use only the top row to fasten. Otherwise you will interfere with the Z-endstop switch!
Happy printing everyone!
Best regards Frederik
3d model print parameters
- Ninjaflex (recommended)- SoftPLA
- InnoFlex
- any TPE filament you have
- one, or two zip-ties...
![[Old Version] Lars' Ultralight Ultimaker XY Blocks](https://www.3dforprint.com/modelos/4649/old-version-lars-ultralight-ultimaker-xy-blocks1_medium.jpg)
